Author: Clayton

New Taper Shaper in action

New Taper Shaper in action

While working the finishes of my first three sticks, I’ve learned how to get this time saver running… The fuzz on the left end is a piece of tack cloth, which I’m using to create enough friction to spin the stick against the 60 degree pin. I used a 60 degree center finder on the […]

Read More

Purple Object Ball Eater

Purple Object Ball Eater

Almost done. Sooooooo close. First video from earlier this afternoon. I’ve learned a lot of refinements to my process while building this stick. I’m polishing now, at 5000 grit. It’s looking good. Likely be back tonight with another video. With a layer of wax and a buff. I’ll add wax, let it harden and buff […]

Read More

Morning Update: 8/31

Morning Update: 8/31

Dennis’s Stick: Almost there. The butt is 99% finished. I’m letting the wax firm up before buffing out. The shaft is complete, but an experiment I haven’t revealed will either look awesome or I’ll do another shaft. Purple Object Ball Eater: This is where Dennis’ stick was yesterday. The finish is substantial. It’s built up […]

Read More

Morning Update 8/30

Morning Update 8/30

Custom sticks near completion. Sometimes farting around the shop, tinkering, experimenting, I’ll do something the wrong way just to see what happens. Sometime if I get the time I’ll tell you about how epoxy stays wet underneath while curing, even when the outside is hard. Fast forward to… That’s why the finishing process takes a […]

Read More

Atheists

Atheists

I used to be one. A few of my closest friends are atheists. I have no problem with atheists any more than I have a problem with someone who gets a different answer than I do working the following problem: (3x)*(4x)+19b/.1002*(102+1/2/2/4)*14a = I doubt the above is math, which makes it even more like the […]

Read More